Skip to main content

Some Massachusetts Highway Photos

I took a trip north from North Carolina to Massachusetts for the Fourth. The route up, if you're curious was my 'land route' vs. a 'coastal route'. It is basically taking NC/VA 86 to US 29 north through central Virginia to US 17, then getting over to US 15 in MD and into PA. The rest of PA via I-83, I-81 and I-84. Then continuing on I-84 through NY and into CT then I-691, CT 66, CT 16, CT 2, I-395, and the CT turnpike stub to get to RI where it was US 6 East, I-295 North to MA getting on I-95 north to I-93/US 1 north.

Since there wasn't anything too new or interesting going up I saved my photos for new signs that had been put up along MA/Pilgrims Highway between Exits 11 and 20 since my last visit. The original signs from Exit 12 to 15 were ground mounted. The new ones are also except at the interchanges themselves where they've been replaced by cantilevered signs such as:the one above for Exit 12 MA 139. Some control cities on some of the signs has changed, such as the following for Exit 14, MA 228:
The original destinations listed were Rockland and Nantasket. Hingham was on a secondary destination sign, which now lists Nantasket. The other noted change is for the following exit 15, which originally northbound only listed S. Hingham, S. Weymouth. It is now:
They also changed the wording for Exit 19 which simply said 'Quincy, T station. Many motorists thought the sign implied one destination, the Quincy Center MBTA station, which it did not. It was replaced with the following with the addition of Burgin Parkway which goes to Quincy Center and the T station (Quincy Adams) separated by a line:
The most interesting signage is the replacements for the I-93 interchange, Exit 20. Individual signage for I-93 North and South has been replaced (or will be replaced, the 1 mile sign seen on Steve Anderson's BostonRoads site was still up as of July 20) by diagrammatic signage:
The other most noticeable change is the inclusion of only the interstate routes, not the other highway designations (US 1, MA 3) from the signs. This is due to past MassHighway signage practices. For a greater explanation of this and to see additional Exit 20 signage and also larger versions of the photos here and additional ones, please go to my Massachusetts Highway Photos Page.

Some other Mass. highway notes, no photos unfortunately:
With the replacement of the Sagamore rotary with an interchange, MA 3 northbound is Exit 1A off of US 6 and US 6 East exits itself as Exit 1B. The MA 6A exit both ways is Exit 1C.
MassHighway had a project that was repaving the SE Expressway from Savin Hill to the Braintree Split. At its conclusion a sign replacement project will start along the same section and continue along I-93 to Randolph this fall ( have a photo of a sign to be replaced on my photo page).
There is a cutout US 1 shield at the I-93 end of the South Boston Haul Road pointing to the ramp to I-93 south, the MA 3 sign is missing.
The I-93/US 1 North Mass. Green signs at Columbia Road have disappeared, they still exist at the southbound ramp.
They have added an overhead South I-93/US1/MA 3 small overhead sign south of the Mass. Ave exit, and have an additional overhead sign assembly with space for one about 1/4 mile south of that.
The Big Dig tunnel ramp to I-93 South from Leverett circle was the only ramp that included additional signs for US 1 and MA 3 posted on the BGS support poles.

The route back was basically the reverse as the way up, except I continued on I-81 South through Virginia to I-64 then I-64 East back to US 29. I also took US 29 further south to Greensboro so I could check on I-74 progress for my previous post.

If there are other questions about what I may have seen on my trip, let me know.

Comments

Steve A said…
A few weeks ago I finally got to try the Burgin Pkwy. exit, after it was re-signed from the freeways. Well, guess what - the old signs are still up on the exit. As a sign guy, I thought it was worth it.

Popular posts from this blog

The rogue G28-2 California State Highway Spades

In this short blog we look at the somewhat rare but not unheard-of rogue G28-2 California State Highway Spades affixed to guide signs. Part 1; what is the G28-2 California State Highway Spade?  The  Caltrans Manual of Uniform Traffic Control Devices Sign Chart from 2014  ("Caltrans MUTCD") dictates the types of signs and highway shields permitted for traffic control use in California.  California is known for it's more ornate cut-out shields which are used for, US Routes, Interstate Highways, and State Routes.  These shields are intended to be applied as standalone reassurance signs but aren't explicitly limited to said function and occasionally appear in error on guide signs.  The common shields which are typically found through California are: US Route:  G26-2 Interstate:  G27-2 State Highway:  G28-2 The Caltrans MUTCD provides alternative shields for, US Routes, Interstate Highways, and State Routes.  These alternative shields are intended for guide sign usage.  Th

US Route 101 in Benbow, Garberville and Redway

The communities of Benbow, Garberville and Redway can all be found along US Route 101 within southern Humboldt County.  The former surface alignment of US Route 101 in Garberville and Redway once crossed the Garberville Bluffs along what is now Redwood Drive via a corridor constructed as part of the Redwood Highway during the 1910s.  US Route 101 through Benbow, Garberville and Redway was modernized by 1935.  US Route 101 would eventually be upgraded to freeway standards in Benbow, Garberville and Redway by extension of the Redwood Freeway during 1966-68.  As the cover photo the original grade of US Route 101 and the Redwood Highway can be seen at the Garberville Bluffs during 1934.  US Route 101 can be seen in the communities of Benbow, Garberville and Redway on the 1935 Division of Highways Map of Humboldt County .   The history of US Route 101 in Benbow, Garberville and Redway Benbow, Garberville and Redway lie on the banks of the South Fork Eel River of southern Humboldt County.  D

Patterson Pass Road

Recently on a day trip to the San Francisco Bay Area I traversed the Diablo Range eastbound via Patterson Pass Road. Patterson Pass Road is an approximately 13 mile roadway which starts at Mines Road in Livermore of Alameda County.  Patterson Pass Road eastward ascends over the approximately 1,600 foot namesake Patterson Pass into San Joaquin County where it ends at Interstate 580 near Tracy.  Patterson Pass Road has an infamous reputation as being a dangerous roadway due to the lengthy one-lane section and heavy rush-hour commute traffic. Patterson Pass is one of the earliest documented European paths of travel over the Diablo Range as it was explored during the 1775-1776 Spanish Expedition led by Juan Bautista de Anza.  The 1775-1776 Spanish expedition charted out much of San Francisco Bay which led to the founding of the Presidio of San Francisco and Mission San Francisco de Asis.  Patterson Pass Road between Cross Road east to Midway Road is part of the Juan Bautista de Anza