Skip to main content

Washington State Route 303 and Washington State Route 308

Initially I was going to create two posts for Washington State Routes 303 and 308 but decided to combine them given how closely related the history of both are.  Below I'll document WA 303 first followed by WA 308.



Washington State Route 303 is an approximately 9.3 mile state highway entirely located in Kitsap County.  WA 303 runs from WA 3 in Silverdale southeast to to WA 304 in Bremerton.  From WA 3 in Silverdale the alignment of WA 303 is on a short freeway known as Waaga Way which becomes an at-grade expressway at Bucklin Hill Road.









WA 303 has a significant junction with Brownsville Highway which was once part of the route.  Prior to the completion of the Waaga Way Freeway in 1991 WA 303 ran north to Keyport and what is now WA 308.  WA 303 was created out of WA PSH 21B when the state highways were renumbered in 1964.  I'm to understand that WA 308 was created out of WA 303 in 1971 from Keyport west to WA 3.


As WA 303 turns southward it becomes Warren Avenue and enters the city of Bremerton.  Traffic is greeted by this odd sign  announcing the city boundary of Bremerton.


WA 303 once had a junction with WA 306 at Sylvan Way.  WA 306 was a short state highway that continued east to Illahee State Park.  WA 306 was created out of a spur of WA PSH 21B in 1964 and was deleted possibly in 1993.

WA 303 crosses the Port Washington Narrows on the Warren Avenue Bridge into downtown Bremerton. 




The Warren Avenue Bridge was completed in 1958 which was a routing replacement of the 1930  Manette Bridge.  The Warren Avenue Bridge made for a much more direct route into downtown Bremerton than the 1930 Manette Bridge.  The 1930 Manette Bridge routing required using Wheaton Way to traverse further south on the Port Washington Narrows. On a clear day the 2011 Manette Bridge, Mount Rainier and the Olympic Range can be seen from the Warren Avenue Bridge.





In downtown Bremerton there are various signs on WA 303/Warren Avenue directing traffic to the ferry terminal.  WA 303 ends at WA 304 which is on Burwell Street, ferry traffic must turn east on WA 304 to reach the Bremerton-Seattle Ferry.








WA 308 is approximately 3.4 miles and begins at a dead-end gate at the Naval Base Kitsap Keyport.





WA 308 westbound traverses through Keyport before emerging over a lagoon.  WA 308 has a minor junction with Brownsville Highway which as mentioned above was part of WA 303.







There isn't a ton of signage on WA 308 but it does exist west of Brownsville Highway.





WA 308 junctions Silverdale Way/Viking Way which was the original alignment of WA 3.






WA 308 continues west until it reaches a junction with WA 3 where it terminates.






For reference the 1956 Washington State Highway Map shows the alignment of WA PSH 21B before the 1964 state highway renumbering.

1956 State Highway Map


Comments

Popular posts from this blog

Grand Loop Road of Yellowstone National Park

  Grand Loop Road is a 140 mile loop highway which traverses the interior of Yellowstone National Park.  Grand Loop Road connects all of the major attractions and geological features of Yellowstone National Park along with the entrance roads.  Grand Loop Road is a seasonal highway and despite some conjecture never has been part of the US Route System.   Part 1; the history of Grand Loop Road The majority of history pertaining to Grand Loop Road was taken from the below National Park Service article: Historic Roads - Yellowstone National Park (U.S. National Park Service) (nps.gov) Yellowstone was declared the first National Park of the United States on March 1st, 1872.  The first real highway to access Yellowstone National Park came in 1873 when a tolled facility was constructed from Bozeman, Montana via Yankee Jim Canyon to Mammoth Hot Springs.  Numerous attempts were made to fund construction of roadway infrastructure during the early years of Yellows...

The last 1956-63 era California Sign State Route Spade?

Along southbound California State Route 170 (the Hollywood Freeway Extension) approaching the Hollywood Freeway/Ventura Freeway interchange a white California State Route 134 Sign State Route Spade can be observed on guide sign.  These white spades were specifically used during the 1956-63 era and have become increasingly rare.  This blog is intended to serve as a brief history of the Sign State Route Spade.  We also ask you as the reader, is this last 1956-63 era Sign State Route Spade or do you know of others?  Part 1; the history of the California Sign State Route Spade Prior to the Sign State Route System, the US Route System and the Auto Trails were the only highways in California signed with reassurance markers.  The creation of the US Route System by the American Association of State Highway Officials during November 1926 brought a system of standardized reassurance shields to major highways in California.  Early efforts to create a Sign State Route ...

California State Route 70; the Feather River Highway

From 2017 through to early 2019 I drove the majority of the California State Route 70; the Feather River Highway from CA 89 southwest to CA 99. CA 70 is an approximately 178.5 mile state highway which starts at US 395 near the Nevada State Line and travels west through the Feather River Canyon to CA 99.  CA 70 is often referred to as the Feather River Highway" given it's close association with the river.  Historically CA 70 was previously signed as US 40A and CA 24.  The Legislative Routes prior to the 1964 California Highway Renumbering that made up the current route of CA 70 are as follows: -  Legislative Route Number 21 from US 395 westward to Oroville. -  LRN 87 from Oroville south to Marysville. -  LRN 232 from Marysville to the current junction with CA 99.  CA 70 was even dual signed with CA 99 into Sacramento on what was LRN 232 for a time. The change from US 40A/LRN 21/LRN 87/LRN 232 can be seen by comparing the 1963 State Highway Ma...