Skip to main content

Ghost Town Tuesday; Thompson Springs, UT, Utah State Route 94, and old US 50/6

Back in 2016 I visited the small ghost town of Thompson Springs in Grand County, Utah located at the north terminus of Utah State Route 94 at Old US Route 50/6.


Thompson Springs began as a rail siding in the early 1880s along the Denver and Rio Grande Railroad when rail construction reached Utah.  The Denver and Rio Grande Railroad ultimately spanned from Ogden, UT to the vicinity of Santa Fe, NM.  The Denver and Rio Grande Railroad incorporated in 1870 and had many spur routes in the Rockies in addition to Colorado plateau.  The Denver and Rio Grande Railroad was merged into the Southern Pacific Railroad in 1988.  Cisco can be seen on the 1883 Denver and Rio Grande Railroad map.

1883 Denver and Rio Grande Railroad Map 

The present location of Thompson Springs was near one of the branches of the Spanish Trail and In 1926 US Route 50 was plotted through town.  By 1937 US 6 joined US 50 in Thompson Springs as it was extended to Long Beach, CA.  Cisco would remain a major stopping point on US 50/6 until both highways were multiplexed onto I-70 which was completed on a new alignment to the south.  I'm uncertain of when Utah State Route 94 was first signed as it's original north terminus was 5 miles north of Thompson Springs in Sego via Sego Canyon Road.  The current south terminus of UT 94 was completed to I-70 1969 to act as a connector route from the new alignment of I-70/US 50/6 to Old US 50/6 in downtown Thompson Springs, I'm fairly certain the segment north to Sego was deleted at that time.  Today, UT 94 is a very small route signed on Thompson Canyon Road and is slightly less than 1 mile.  UT 94 is mainly used for access to a gas station in addition to a UDOT maintenance yard.

Thompson Springs did not weather time very well after being bypassed by I-70/US 50/US 6 as it now is a ghost town.  Unlike nearby Cisco the buildings located in Thompson Springs are largely in a decent state of repair.  Below is the north terminus of UT 94 approaching Old US 50/6 houses various abandoned buildings.



Along Old US 50/6 there are various abandoned structures in a variation of decay.  I found the Thompson Motel to be the most interesting to look at.






The Desert Moon Hotel appeared to be the only occupied building left in Thomson Springs.  There is an active RV site still listed at the location on Google Maps.


The Book Cliffs are relatively close to Thompson Springs and can be seen across the railroad tracks on Old US 50/6.





Sego was a coal mining town located at the foot of the Book Cliffs north of Thompson Springs.  Sego was inhabited from 1910 to until 1955 when miles played out.  Sego had a peak population of about 500 residents and a 5.25 railroad spur known as the Ballard & Thompson Railroad which operated from 1911 to 1950.  This 1950 Utah State Highway Map shows Sego north of Thompson Springs connected via UT 94. 

Comments

US 89 said…
UT 94 was created in 1935.

Popular posts from this blog

Grand Loop Road of Yellowstone National Park

  Grand Loop Road is a 140 mile loop highway which traverses the interior of Yellowstone National Park.  Grand Loop Road connects all of the major attractions and geological features of Yellowstone National Park along with the entrance roads.  Grand Loop Road is a seasonal highway and despite some conjecture never has been part of the US Route System.   Part 1; the history of Grand Loop Road The majority of history pertaining to Grand Loop Road was taken from the below National Park Service article: Historic Roads - Yellowstone National Park (U.S. National Park Service) (nps.gov) Yellowstone was declared the first National Park of the United States on March 1st, 1872.  The first real highway to access Yellowstone National Park came in 1873 when a tolled facility was constructed from Bozeman, Montana via Yankee Jim Canyon to Mammoth Hot Springs.  Numerous attempts were made to fund construction of roadway infrastructure during the early years of Yellows...

The last 1956-63 era California Sign State Route Spade?

Along southbound California State Route 170 (the Hollywood Freeway Extension) approaching the Hollywood Freeway/Ventura Freeway interchange a white California State Route 134 Sign State Route Spade can be observed on guide sign.  These white spades were specifically used during the 1956-63 era and have become increasingly rare.  This blog is intended to serve as a brief history of the Sign State Route Spade.  We also ask you as the reader, is this last 1956-63 era Sign State Route Spade or do you know of others?  Part 1; the history of the California Sign State Route Spade Prior to the Sign State Route System, the US Route System and the Auto Trails were the only highways in California signed with reassurance markers.  The creation of the US Route System by the American Association of State Highway Officials during November 1926 brought a system of standardized reassurance shields to major highways in California.  Early efforts to create a Sign State Route ...

California State Route 70; the Feather River Highway

From 2017 through to early 2019 I drove the majority of the California State Route 70; the Feather River Highway from CA 89 southwest to CA 99. CA 70 is an approximately 178.5 mile state highway which starts at US 395 near the Nevada State Line and travels west through the Feather River Canyon to CA 99.  CA 70 is often referred to as the Feather River Highway" given it's close association with the river.  Historically CA 70 was previously signed as US 40A and CA 24.  The Legislative Routes prior to the 1964 California Highway Renumbering that made up the current route of CA 70 are as follows: -  Legislative Route Number 21 from US 395 westward to Oroville. -  LRN 87 from Oroville south to Marysville. -  LRN 232 from Marysville to the current junction with CA 99.  CA 70 was even dual signed with CA 99 into Sacramento on what was LRN 232 for a time. The change from US 40A/LRN 21/LRN 87/LRN 232 can be seen by comparing the 1963 State Highway Ma...