Skip to main content

Oregon Route 62 Rogue Valley Expressway

By

Much of Oregon Route 62 recently in the Medford Area has been moved from Crater Lake Highway to the Rogue Valley Expressway. 

The Rogue Valley Expressway is a 4.5 mile segment of Oregon Route 62 ("OR 62") which is a limited access bypass of Crater Lake Highway.  The Rogue Valley Expressway begins just south of OR 140 and terminates about a half mile from Interstate 5 ("I-5").  The Rogue Valley Expressway was intended to expedite travel between Medford and White City.  


Part 1; the background of the Rogue Valley Expressway

Much of the history of the Rogue Valley Expressway is discussed in the May issue of ODOT Moving Ahead.  According to ODOT Moving Ahead concepts to move OR 62 from Crater Lake Highway between Medford and White City began to emerge in the 1990s  In 2004 project teams met to narrow down the possible design concepts which would be evaluated for Environmental Impact Statements.  The Rogue Valley Expressway was funded in 2009 via $120 million dollars set aside as part of the Oregon Jobs & Transportation Act.  Construction of the Rogue Valley Expressway began in May 2016 and would open to traffic as mainline OR 62 in May 2019.  



 

Part 2; a drive on the Rogue Valley Expressway

As noted above OR 62 joins the Rogue Valley Expressway just south of OR 140 and White City.  OR 62 westbound makes a right turn off of Crater Lake Highway onto the Rogue Valley Expressway.  The former surface alignment of OR 62 on Crater Lake Highway is signed OR 62 Business.  




Despite being fully limited access and not having any interchanges the Rogue Valley Expressway is signed at a typical Oregon 55 MPH urban freeway speed.


The Rogue Valley Expressway makes a southward jog towards Medford and enters the City Limits at Vilas Road overpass. 





The Rogue Valley Expressway skirts the eastern edge of Rogue Valley International-Medford Airport and merges back into Crater Lake Highway approaching I-5. 









Labels:

Comments

Unknown said…
This comment has been removed by the author.
1:54 AM
Jonathan/Beaver State Roads said…
According to the first draft map, the bypass was going to extend further up current OR-62 to White City. There would have been interchanges at Vilas Road, OR-62 (at or near the current northern end of the bypass) and OR-140 (as a cloverleaf). The 2013 FEIS selected a different longer routing: White City would be bypassed to the west to Dutton Road, eliminating the 140 cloverleaf but adding partial interchanges at existing OR-62 at both ends of White City. The interchange at Vilas road also changed from an SPUI to a tight diamond interchange. At some point, the project was rolled back or split into phase; the Vilas Road interchange was removed, and the bypass now ends at OR-62 between Corey Road and Gregory Road.
1:55 AM
Post a Comment

Popular posts from this blog

Crescent City Connection (New Orleans, LA)

By
The Crescent City Connection is a massive dual-span steel truss bridge that spans the lower Mississippi River at downtown New Orleans, about 95 river miles upstream from the mouth of the great river at the Head of Passes Light. If counted as a single bi-directional highway bridge, the parallel spans combine to form the single busiest bridge on the Mississippi River and its importance as a linchpin in the region’s transportation network cannot be overstated. While there have been various schemes over the years to construct bridges downriver from Algiers Point, this bridge has been the southernmost bridge on the Mississippi River since its initial construction in the 1950s. The years immediately following the end of World War II were a transformational period in the history of New Orleans. Already one of the great economic and cultural centers of the American Deep South, it was recognized at this time that major changes and improvements to the city’s transportation infrastructure would b...
Post a Comment
Read more

Old US Route 99 through Tipton, Tulare, and Tagus Ranch

By
This summer I had a look into the alignment history of US Route 99 through the Tulare County communities of Tipton, Tulare, and Tagus Ranch.  While this slab below might seem like much it is one of the few remaining reminders of how US Route 99 was during the 1920s in Tulare County. This blog is part of the larger Gribblenation US Route 99 Page.  For more information pertaining to the other various segments of US Route 99 and it's three-digit child routes check out the link the below. Gribblenation US Route 99 Page Part 1; the history of US Route 99 in Tipton, Tulare, and Tagus Ranch Tipton and Tulare were both founded in 1872 as sidings of the Southern Pacific Railroad.  The Southern Pacific Railroad laid the groundwork for development of southern San Joaquin Valley.  Previous to the Southern Pacific Railroad travel via wagon or foot in Central California tended to avoid San Joaquin Valley in favor of the Stockton-Los Angeles Road.  The Stockton Los Ange...
Post a Comment
Read more

Former US Route 101 and California State Route 41 through Paso Robles

By
Paso Robles is a city located on the Salinas River of San Luis Obispo County, California.  As originally configured the surface alignments of US Route 101 and California State Route 41 converged in downtown Paso Robles.  US Route 101 originally was aligned through Paso Robles via Spring Street.  California State Route 41 entered the City of Paso Robles via Union Road and 13th Street where it intersected US Route 101 at Spring Street.  US Route 101 and California State Route 41 departed Paso Robles southbound via a multiplex which split near Templeton.   Pictured above is the cover of the September/October 1957 California Highways & Public Works which features construction of the Paso Robles Bypass.  Pictured below is the 1935 Division of Highways Map of San Luis Obispo County which depicts US Route 101 and California State Route 41 intersecting in downtown Paso Robles.   Part 1; the history of US Route 101 and California State Route 41 i...
Post a Comment
Read more