Skip to main content

I-40 rockslide uncovers old debates on highway

Editors Note: October 27, 2024 - An update version of this post titled, "Interstate 40's Tumultuous Ride Through the Pigeon River Gorge" is now available.

The Asheville Citizen-Times continues to do a great job covering all the angles of the Interstate 40 Haywood County rock slide.

An article in Sunday's edition provides a strong historical perspective on how the Pigeon River routing of Interstate 40 came about. And perhaps most strikingly, in an article that ran just prior to the highway's opening in the fall of 1968, how engineers from both Tennessee and North Carolina warned "...that slides would probably be a major problem along the route for many years."

On February 12, 1969, not long after the Interstate opened, the first rock slide that would close I-40 occurred.

Like many other Interstates within North Carolina, Interstate 40 through the mountains has a history prior to formation of the Interstate Highway System and was also a heated political battle between local communities.

The discussion for a road that would eventually become Interstate 40 dates back to the 1940's as the idea for interregional highways were being promoted within and outside of North Carolina. North Carolina completed two studies in the 1940's - a 1945 study looked at a French Broad route into Tennessee and a 1948 study looked at a Pigeon River route.

The early 1950's was when the debate between the two routes really heated up. Haywood County leaders publicly argued that a 1921 NC provision that called for the building of roads between county seats including roads that connected to county seats in other states. Haywood officials wanted their road contending that "Madison [County] has had three roads to Tennessee built under this act."

They also mentioned that the right-of-way for the US 25/70 “interregional highway or Super Highway” was too narrow.

The die was cast in June 1952 when NC Governor H. Kerr Scott allocated $1 million towards the Pigeon River road. It also seemed that the state of Tennessee preferred the Pigeon River Route.

When the Interstate Highway System was created in 1956, I-40 would be routed along the Pigeon River route.

It would take over ten years to complete Interstate 40 through Haywood County.

Besides the concerns from engineers about possible slides prior to the highway's opening, there is another aspect to the highway that I learned from this article. The travel lanes for Interstate 40 through the Pigeon River Gorge today are slightly different than they were when the highway opened in 1968.

Beginning in the late 1970s through 1985, and due to the safety concerns from frequent slides, the travel lanes of Interstate 40 were shifted towards the Pigeon River. What happened were the eastbound lanes were shifted over to what were then the westbound lanes. The westbound lanes were then constructed closer to the Pigeon River. From there, the slopes were stabilized as much as possible by clearing rocks, isolated blasting, rock bolts and mesh, along with barrier walls.

Ironically, that same year a rock slide at mile marker 4 closed the highway for nearly nine months.

Since then more repairs and safety upgrades have been made in between the next slide, and the same will be done once I-40 re-opens. The geography of the area makes the perfect fix next to impossible. The ultimate solution would cost millions, possibly billions, of dollars to complete and would certainly face numerous financial let alone environmental hurdles.

Most engineers today admit that if with modern technology and standards, Interstate 40 through the Pigeon River Gorge wouldn't even be built.

“I would say today, if we had no road through Haywood, with the advances in geotechnology, we would never try to build an interstate-type road down there, unless there was just no place else to put it,” retired NCDOT engineer Stan Hyatt said. “It's just an area that's full of nothing but fractured rock waiting to fall off.”

Comments

J-Dawg's Realm said…
Do you have any pictures or anything showing where they planned to put (what is now) I-40 before they put it along Pigeon River? Driving that stretch of highway, I have to give them the credit that is due -- putting a highway thru there like they did when they did is a feat! Until the slide, I have been thru there no less than 2-3 dozen times,and I am astounded each and every time at how they were able to build such a highway not only on unstable ground and make it as stable as they do with the amount of truck traffic that travels through there.

Popular posts from this blog

Grand Loop Road of Yellowstone National Park

  Grand Loop Road is a 140 mile loop highway which traverses the interior of Yellowstone National Park.  Grand Loop Road connects all of the major attractions and geological features of Yellowstone National Park along with the entrance roads.  Grand Loop Road is a seasonal highway and despite some conjecture never has been part of the US Route System.   Part 1; the history of Grand Loop Road The majority of history pertaining to Grand Loop Road was taken from the below National Park Service article: Historic Roads - Yellowstone National Park (U.S. National Park Service) (nps.gov) Yellowstone was declared the first National Park of the United States on March 1st, 1872.  The first real highway to access Yellowstone National Park came in 1873 when a tolled facility was constructed from Bozeman, Montana via Yankee Jim Canyon to Mammoth Hot Springs.  Numerous attempts were made to fund construction of roadway infrastructure during the early years of Yellows...

The last 1956-63 era California Sign State Route Spade?

Along southbound California State Route 170 (the Hollywood Freeway Extension) approaching the Hollywood Freeway/Ventura Freeway interchange a white California State Route 134 Sign State Route Spade can be observed on guide sign.  These white spades were specifically used during the 1956-63 era and have become increasingly rare.  This blog is intended to serve as a brief history of the Sign State Route Spade.  We also ask you as the reader, is this last 1956-63 era Sign State Route Spade or do you know of others?  Part 1; the history of the California Sign State Route Spade Prior to the Sign State Route System, the US Route System and the Auto Trails were the only highways in California signed with reassurance markers.  The creation of the US Route System by the American Association of State Highway Officials during November 1926 brought a system of standardized reassurance shields to major highways in California.  Early efforts to create a Sign State Route ...

California State Route 70; the Feather River Highway

From 2017 through to early 2019 I drove the majority of the California State Route 70; the Feather River Highway from CA 89 southwest to CA 99. CA 70 is an approximately 178.5 mile state highway which starts at US 395 near the Nevada State Line and travels west through the Feather River Canyon to CA 99.  CA 70 is often referred to as the Feather River Highway" given it's close association with the river.  Historically CA 70 was previously signed as US 40A and CA 24.  The Legislative Routes prior to the 1964 California Highway Renumbering that made up the current route of CA 70 are as follows: -  Legislative Route Number 21 from US 395 westward to Oroville. -  LRN 87 from Oroville south to Marysville. -  LRN 232 from Marysville to the current junction with CA 99.  CA 70 was even dual signed with CA 99 into Sacramento on what was LRN 232 for a time. The change from US 40A/LRN 21/LRN 87/LRN 232 can be seen by comparing the 1963 State Highway Ma...