Skip to main content

PA: Contractor defaults on Findlay Connecter contract....construction at a pause

Construction on the southern two and a half miles of the Findlay Connector, which will connect US 22 to PA 60 and the Pittsburgh Airport, has ground to a halt recently. The reason, the contractor, Smith and Johnson, was declared in default by the PA Turnpike commission as a result of Smith and Johnson's financial woes. See article in today's Post-Gazette.

Smith and Johnson was awarded the contract to build Section 54C which runs from US 22 near Bavington to just north of Bald Knob Road. The contract included interchanges at US 22 and Bald Knob Road. According to the Post-Gazette article: Section 54C is 65 percent complete while Sections 54A and 54B are 77 and 76 percent complete, respectively. Most of the troubles began in the fall. And although a bridge carrying Candor Road over US 22 was demolished in late January, Smith and Johnson was pulling out from the construction site. On January 18, the Turnpike Commission offered the company a chance to right the ship, but those efforts failed and the Turnpike declared them in default on February 8.

Problems in addition to falling behind schedule include shortpaying or not paying at all their subcontractors and suppliers.

This would be the third major project in two states that Smith and Johnson has pulled out of. In September of 2005, Smith and Johnson halted work on a six mile segment of a 50 mile highway called the O'Bannon Expressway in Southern Indiana. Citing unanticipated $3,000 fuel costs and began a tussle with Indiana over who should pay for the additional costs.

According to this WISH-TV news story from September 15, 2005:

Indiana Department of Transportation officials said the contractor is bound by its contract to complete the job for the price it bid and that the state has no policy for allowing fuel-cost escalations. "This is very unusual. This hasn't happened anywhere else (in the state) this year," said department spokeswoman Afua Anokwa.

The company also stopped work on a US 231 project in Rockport, Indiana at the same time. The company laid of 30 employees.

It appears that this was a ploy to get INDOT's attention. Bob Johnson, general superintendent for S &J, said in a September 16, 2005 issue of Land Line Online that it was standard procedure for other partners to absorb part of the cost.

“There is sort of a standard they’ve used in other states,” he said. “The contractor absorbs the first 20 percent. Then after that, the governing agency or the contracting agency usually helps out with the fuel cost.”

The state ordered them back to work and they obliged.

However, according to today's article...it appears the company has gone out of business.

"As far as we know, they closed down the highway construction side of their business," Mr. Agnello said. "Basically, they're out of business."
As this develops, more will be reported here.




Comments

Popular posts from this blog

Grand Loop Road of Yellowstone National Park

  Grand Loop Road is a 140 mile loop highway which traverses the interior of Yellowstone National Park.  Grand Loop Road connects all of the major attractions and geological features of Yellowstone National Park along with the entrance roads.  Grand Loop Road is a seasonal highway and despite some conjecture never has been part of the US Route System.   Part 1; the history of Grand Loop Road The majority of history pertaining to Grand Loop Road was taken from the below National Park Service article: Historic Roads - Yellowstone National Park (U.S. National Park Service) (nps.gov) Yellowstone was declared the first National Park of the United States on March 1st, 1872.  The first real highway to access Yellowstone National Park came in 1873 when a tolled facility was constructed from Bozeman, Montana via Yankee Jim Canyon to Mammoth Hot Springs.  Numerous attempts were made to fund construction of roadway infrastructure during the early years of Yellows...

The last 1956-63 era California Sign State Route Spade?

Along southbound California State Route 170 (the Hollywood Freeway Extension) approaching the Hollywood Freeway/Ventura Freeway interchange a white California State Route 134 Sign State Route Spade can be observed on guide sign.  These white spades were specifically used during the 1956-63 era and have become increasingly rare.  This blog is intended to serve as a brief history of the Sign State Route Spade.  We also ask you as the reader, is this last 1956-63 era Sign State Route Spade or do you know of others?  Part 1; the history of the California Sign State Route Spade Prior to the Sign State Route System, the US Route System and the Auto Trails were the only highways in California signed with reassurance markers.  The creation of the US Route System by the American Association of State Highway Officials during November 1926 brought a system of standardized reassurance shields to major highways in California.  Early efforts to create a Sign State Route ...

California State Route 70; the Feather River Highway

From 2017 through to early 2019 I drove the majority of the California State Route 70; the Feather River Highway from CA 89 southwest to CA 99. CA 70 is an approximately 178.5 mile state highway which starts at US 395 near the Nevada State Line and travels west through the Feather River Canyon to CA 99.  CA 70 is often referred to as the Feather River Highway" given it's close association with the river.  Historically CA 70 was previously signed as US 40A and CA 24.  The Legislative Routes prior to the 1964 California Highway Renumbering that made up the current route of CA 70 are as follows: -  Legislative Route Number 21 from US 395 westward to Oroville. -  LRN 87 from Oroville south to Marysville. -  LRN 232 from Marysville to the current junction with CA 99.  CA 70 was even dual signed with CA 99 into Sacramento on what was LRN 232 for a time. The change from US 40A/LRN 21/LRN 87/LRN 232 can be seen by comparing the 1963 State Highway Ma...