Skip to main content

Columbus Day I-74 Road Trip Discoveries

Image
By
I took a trip back to the completely open I-74/US 74 freeway to check out the westbound side, which was closed before, and to see what they had done to solve the exit number problem.

I approached the new freeway via I-95. The new Exit 13 signs start out 2 miles in advance.
They have completely demolished the former US 74 (Exit 14) ramps as you can see just before the ramps for the new exit begin. The closeness of the 2 ramps shows why they could not keep the old ramp in service...
The ramps lead to, depending on your point of view, some of the most unique or most confusing BGSs ever to appear on an interstate. Here are photos from both north and south off ramps...
These are taken from the C/D ramps heading southbound on I-95, the only destination I-74 currently goes to is Laurinburg.

I took the eastbound ramp to see how close to completion the freeway was east of I-95.

Coming back, I did a quick 180 to show the signs from the C/D ramps going northbound for those who may be coming to investigate from points south.

This is from the on ramp to Alternate US 74. As you can see there still doing work there, though all the signs are up. Again, these signs may be confusing to some. They have not finished putting the final coat of pavement on the last 2 miles of the freeway and there are no I-74 signs or mileposts past the Alternate 74 exit. Here's a closeup of signs going further along Alternate 74...
For those wondering what the control cities at the various exits east of I-95 are, this should satisfy your curiosity...
Laurinburg is used in place of Rockingham at on ramps closer to that city.

I took the following photos to show how the interchange at NC 710 had changed, formerly the end of the freeway....
This is the NC 710 exit westbound. First, you'll notice the old exit numbers are used. They have started the process of removing the original mileposts that are wrong between what is now Exit 203 (Dew Rd) and is still Exit 220 (Alt/Bus US 74) to the west, but the none of the exit numbers on the old stretch have been changed to back the new. This will probably be Exit 199.

The previous version of the photo you may have seen had the east 74/74 signs covered up. This ramp design is unique in that the entrance is to the left due to the existing road the van is parked on to the right.

I continued on to Laurinburg to see if they had switched out the previous 55 mph speed limit signs. Not only is the speed now 70 for all of the new freeway, the 70 mph limit continues all along the Maxton Bypass until the Scotland County line where it is reduced to 60 mph. The 70 mph stretch is still not up to Interstate standards, as this photo will attest...
Exit numbers have not changed along the Laurinburg Bypass, but they have been covered over for what was Exit 207 (Business US 74) and Exit 209, since these match numbers further east, they also need to cover Exit 210 and Exit 212, since these will be repeats as well. Here's one of the exit signs along the Bypass...
This exit number will be changed to something around 186. For a complete list of current numbers and probable future ones, see my I-74 Exit List.

Lastly, here's a photo of the only triplex eastbound on ramp sign displays in Laurinburg...
Does adding US 501 to the mix make it more or less confusing?

Additional I-73/74 Notes: I returned up US 220 and the I-73/74 corridor. A stretch of the substandard I-73/74 highway north of Candor is signed as a work zone with signs every 1/2 mile warning of 'Low/Soft Shoulder" on both sides of the northbound roadway. The only thing I can think this can be is the widening of the shoulders to Interstate standards. However, according to the latest state TIP this project is supposed to be a couple of years off. Did they get money to do it early, or is NCDOT going overboard in warning of future construction?

Speaking of construction, progress is proceeding on the 2 Visitor's Centers/ Rest Areas near the Randolph/Montgomery county line. The freeway is only 1 lane in each direction around the construction zone. The future northbound rest area can be seen in the distance in the photo below...
Some of the photos above and others will be featured in updated I-74 Segment 15 and Segment 16 pages in the near future.
Labels:

Comments

Anonymous said…
very nice .. descriptions and pictures too. It will be nice when it is all done. It will be still a few more years.


Dino
3:14 PM
Anonymous said…
I don't get how some freeways are classified as Interstates when they have grass shoulders, while others with substandard paved shoulders cannot be posted as an Interstate.
9:54 PM
weavervillefreak said…
because interstates classify as a highway where it intersects other states (Example: Interstate 40). Sure some roads are classified as interstates when they are only 9 miles long that circles a city, they should have called them SPURS.
9:26 AM
Post a Comment

Popular posts from this blog

The case to move Interstate 73 in Southern Ohio onto US 33

By
Every decade or so, Ohio pushes to revisit the proposed Interstate 73 that would connect Michigan to Myrtle Beach, South Carolina.  It's been happening since Congress legislated the route in 1991.  Within Ohio, Interstate 73 generally follows the US 23 corridor from Portsmouth through Columbus to Toledo, and into Michigan. Since High Priority Corridor Five was created , Ohio has really done nothing to move forward with Interstate 73.  Sure, there have been feasibility studies here and there.  But actual dollars and construction just haven't occurred. The US 33 Nelsonville Bypass appears to have been built to Interstate standards. However, Ohio has been slowly upgrading US 33 to a full freeway through Southeastern Ohio.  Bypasses of Lancaster and Nelsonville opened in 2004 and 2013, respectively.  Other sections of two-lane road are being twinned, some to freeway or, at a minimum, to expressway standards.  Currently, a $274 million widening project in...
Post a Comment
Read more

Local Sign Find - The last remnant of Business Interstate 95 between Kenly and Rocky Mount , NC

By
As you head north on Interstate 95 at Exit 107 for Kenly and US 301, you'll notice something odd about the overhead sign for the exit.  Peeling off the sign for all that can see is the word 'NORTH' off-center from the US 301.  This old sign (probably close to original from when this section of I-95 opened - more on that in a little bit) gives a hint to a short-lived Business Interstate Route that ran from here to Rocky Mount. The last hint of the Kenly-Wilson-Rocky Mount Business I-95 (Shaun White - August 2020) Interstate 95 in North Carolina has a unique history.  But one of the overlooked and forgotten pieces of Interstate 95 in North Carolina is the 38 mile section between Kenly and Rocky Mount.  When opened to traffic in late 1978, it was the next to last piece of Interstate 95 in North Carolina to open replacing a four lane US 301 from Battleboro through Rocky Mount and Wilson to eventually tying back into the Interstate in Kenly. Though it was not delayed in l...
Post a Comment
Read more

Nostalgia fast food with style - Returning to Rax

By
Nostalgia. It sells. It evokes, and more accurately, warps memories of days gone by.  Things were better, simpler, and we eat it up. Nostalgia can make you drive three hours and over a hundred miles out of your way just to reconnect with a dying fast-food restaurant you last enjoyed in the early to mid-90s.  That person was me - that restaurant was Rax. I could go on about Rax's history, but in short, Rax was briefly a very popular roast beef fast-food chain.  Growing up in the 80s and early 90s in Western PA, Rax was the good fast-food spot.  The milkshakes.  (Personally, the chocolate chip milkshake was heaven.)  Uncle Alligator Kids Meal with the chocolate chip cookie. Take that McDonald's Happy Meal!  The fancy salad and hot foods bar.  Going to Rax was special.  Like so many similar restaurants, various investments, management decisions, etc., led Rax to almost disappear overnight.  By the time I graduated college in late 1999, abou...
Post a Comment
Read more